Views: 232

Reply to This

Replies to This Discussion

… and I should also mention that there are other archived articles that have appeared in publications like OnPasture here on the forum that can be found by searching older posts. 

Hi Brett,
I am reading "Managing vegetation in silvopastures". You say "we try to maintain a grazing density of at least 100,000 lbs per acre on the open pastures with our cow-calf herd to balance the considerations of time vs trampling."   
However, doesn't that number need a time period such as 100,000 lbs /acre /year?
Would you guess that converting that to sheep be about the same. So if your cow-calfs were 2000#/au and our ewe-lambs were 150#/au.
So we are looking for units (#lbs au * # au pairs * (# graze days/ total days in a year))/ acres in the rotation protocol"
For our operation where we have to constraint our flock from some paddocks at wet times of the year and supply bales mostly in the late summer, early spring .....
(50 pairs in flock * 150# per pair * (170 graze days/ 365 days))  / ( # of acres in the intensive rotational grazing schedule ) =388 lbs per flock per acre per year
I would have to bale feed them in the winter on that ground to get near 100,000 if I am calculating properly. 
It would be great to supply a table with these examples for sheep and cows.
Also this does not include considerations of timing of this type of treatment. For example, putting animals back on the paddock twice a year will be less effective than getting them back on every month. 
Thanks-- Corrections, Thoughts ? Clarifications?
Joanne

Joanne,

These are good questions as I think many graziers (including myself) tend to get confused over the concepts of density vs. stocking, etc.  

Density is independent of time.  It's simply the amount of animals (expressed in # of head, pounds or standardized conversion like "animal unit") per acre.  The greater the density, the more frequent the rotation to keep them fed.  As an example, if I put a herd that weighs 50,000 lbs on a half-acre, I've created 100,000 lbs of density.  At that density, I'd likely have to move the animals at least a couple times/day, depending on just how much food was there to begin with.

Stocking (rate) is density for a period of time, regardless of whether or not the site can actually support that number of animals.  Stocking capacity is how many animals an area can support for a unit of time.  Examples:  a strategy used by some grazing operations is to adjust the stocking rate over the course of the season to take advantages of surplus grass.  One local friend does this by custom grazing our heifers from early May till early August before they come back to the farm to be bred.  During this period, he has a higher stocking rate on his pastures.  The stocking capacity of his farm, however, doesn't change much from one year to the next.  He can support a certain number of pounds of animals on his farm each year, with some variation for weather.  

The stocking capacity of newly-established silvopastures is usually quite low.  But any grazing system under good management should see a gradual increase in stocking capacity over time until it matures, at which point the annual increase in capacity will level off.

For calculation purposes, different classes of ruminant livestock are normally converted to Animal Units (1000 pound units), though small differences may exist between classes depending on the type and quality of feed.  In other words, in a brushy young silvopasture, an AU of goats or sheep may be more efficient (potentially higher stocking rate) than an AU of cattle.  Something to keep in mind if trying to really fine-tune your stocking rate, but there are numerous variables that can affect the math.  

Multi-species grazing in a single group can distort the calculations as the large animals may utilize forages & browse not preferred by the small animals, and vice-versa.  You can find plenty of good articles on-line about the benefits of combining species (as well as the challenges and downsides).

Density (how much), frequency (how often), duration (how long), timing (when, in terms of point in the growing season or stage of maturity of the plants) as well as other variables like ground conditions and type of livestock combine to express the "grazing impact".  This is the bottom-line consideration when attempting to manage the understory vegetation in silvopastures.  If you don't take all of them in to account, you may not get sufficient impact to promote the good plants and limit the bad ones.  Animal impact is about the only practical impact that we have to manage vegetation in silvopastures as the trees, shrubs and other obstacles prevent the use of tools commonly used in open pastures (mowing, spraying, tillage) 

Reply to Discussion

RSS

Forum

Starting a silvopasture in the woods

Started by Joe Repetur. Last reply by Joe Repetur Jun 5. 2 Replies

We have about 20+ acres of woods we can use as a silvopasture, but we're not sure how to start it. The woods are a mess, and we're not sure if we should "clear cut" and start over, or?? We have a lot…Continue

protecting young trees during fly season

Started by Brett Chedzoy. Last reply by Brett Chedzoy Jun 2. 2 Replies

As we get ready to move our 5 bulls from the "bull pen" pastures this weekend off to their respective breeding groups and other parts of the farm, I'm reminded that we're currently at the height of…Continue

Help: Oak acorn fungus/blight?

Started by Joanne Vaughn. Last reply by Joanne Vaughn May 23. 3 Replies

We have an oak tree with numerous acorns. All acorns are blighted like…Continue

Tags: acorns, blight, fungus, oak

Feed values for fodder trees

Started by jackie milne. Last reply by jackie milne May 5. 4 Replies

Hello everyone!We live in northern Canada, we have Aspen, birch, popular, willows and various wild roses and berry shrubs as well as white and black spruce mainly some pine. What I have been trying…Continue

Members

© 2020   Created by Peter Smallidge.   Powered by

Badges  |  Report an Issue  |  Terms of Service